Rezultati iskanja za '- EN'

The EK-Loop Screwdriver Basic Set includes an aluminum alloy handle with a strong magnetic bit socket, hexagonal grip, and swivel top – plus 48 precision driver bits inside a plastic tray.

EK-Loop Hard Tube 16mm 0.8m Pre-Bent 90° - Acrylic (6pcs) is a 6-pack of 12/16mm(ID/OD) acrylic tubing bent to a 90-degree angle. Intended to help liquid cooling beginners, but also bring a quality of life improvement for liquid cooling enthusiasts by shortening the time and effort needed to bend the tubing and build the systems.

EK-Loop Hard Tube 14mm 0.8m Pre-Bent 90° - Acrylic (6pcs) is a 6-pack of 10/14mm(ID/OD) acrylic tubing bent to a 90-degree angle. Intended to help liquid cooling beginners, but also bring a quality of life improvement for liquid cooling enthusiasts by shortening the time and effort needed to bend the tubing and build the systems.

EK-Loop Hard Tube 12mm 0.8m Pre-Bent 90° - Acrylic (6pcs) is a 6-pack of 10/12mm(ID/OD) acrylic tubing bent to a 90-degree angle. Intended to help liquid cooling beginners, but also bring a quality of life improvement for liquid cooling enthusiasts by shortening the time and effort needed to bend the tubing and build the systems.

The EK-RGB 4-Way Splitter Cable allows users to connect up to four RGB products to one RGB source so that they can build an aesthetically beautiful lighting system. It features standard 4-pin RGB headers and the male-male connector pins are also included in the packaging.

EK-Loop Connect - Temperature Plug Sensor is an NTC (negative temperature coefficient) coolant temperature sensor. It allows users to get a precise coolant temperature measurement and to fine-tune the radiator fan speed for an optimal balance between acoustics and performance.

A coolant level sensor provides a warning when the reservoir reaches a point where it would be prudent to top it off. Due to the coolant evaporation through the tubing, it makes sure the pump never runs dry. Also, in case of a leak, it warns you of the coolant level being below its optimal value.

The EK-Loop CMS touch fastener allows you to securely connect two RGB (and D-RGB) connectors without any worry about them coming apart later, which is pretty usual during the transport of a PC.

Replacement individually addressable D-RGB strip with densely packed LEDs that is used for upgrading existing EK products. The strip is 200mm long and features 30 diodes for 15 diodes per 100mm. It can replace standard RGB strips in CPU blocks, monoblocks, reservoirs, and pump-combos. The strip is connected via a 3-pin connector to supported 5V headers that are present on most modern motherboards.