The EK-Loop Torque Screwdriver - 0.6Nm is a precision screwdriver with 5 enclosed bits that will allow you to precisely fasten screws. Assemble and maintain your water-cooling equipment without the risk of over-torquing and damaging your gear. It comes with standard bits like Allen (Hex) and Phillips ones, which will be ideal for most water-cooling products like CPU and GPU water blocks, fan and radiator screws, various pump/reservoir mounts, and much more. 

EK-Loop D-RGB LED Edge Diffused Strip (500mm) – White is a specialized LED strip that has a side-illumination going through a diffuser. It can be utilized for more focused applications when you wish illumination on a specific location and as a detail light. It uses addressable RGB diodes, allowing full control of each diode separately.

Replacement individually addressable RGB strip for upgrading existing EK products. The strip is 400mm long and can replace standard RGB strips in CPU blocks, monoblocks, reservoirs, and pump-combos. The strip is connected via a 3-pin connector to supported 5V headers that are present on most modern motherboards or EK-Loop Connect.

Technical data:

EK-Loop D-RGB LED Magnetic Strip (600mm) is a 600mm-long addressable RGB LED strip that connects to a PC motherboard or a D-RGB controller via a standard 3-pin 5V connector (+5V, Data, Blocked, Ground). It has a density of 54LEDs/m with a total of 33 separately controllable LEDs on its 600mm long strip. The primary form of mounting on a PC case is via magnets, but it also has a secondary option, an adhesive tape that can stick to any flat surface. It's utilized by removing the protective foil from the back of the strip. The strip is encased in a high-quality silicone housing improves light uniformity and protects the strip.

EK-Loop D-RGB 3-Way Splitter Cable enables users to connect up to three Addressable D-RGB products to one Addressable D-RGB source header (Pinout: +5V, D, Blocked, Ground).

The  EK-Loop D-RGB Splitter Cable 2-Way  allows users to connect up to two digitally addressable RGB products to a single D-RGB (addressable) motherboard or controller header so that they can synchronize all their D-RGB products.

The EK-Loop Screwdriver Basic Set includes an aluminum alloy handle with a strong magnetic bit socket, hexagonal grip, and swivel top – plus 48 precision driver bits inside a plastic tray.

The EK-Loop Adapter Molex to SATA enables you to connect your 4-pin MOLEX products - like D5 and DDC pumps to a SATA power connector on your PSU.